DNA Race Mode
Big thanks to JeFizz for a great tutorial - How to enable "Race" mode on non-QV 2018 (maybe 2017-2019)
New module:
I've used OBD-Protect interface and gray & blue adapter and registered version of Multiecoscan software 4.7R3.
Interface settings in MES:
See this tutorial how to disassemble center console. Below are two additional pictures of module location.
In MES I chose Type 2/DNA option and execute PROXI ALIGNMENT. The WRITE procedure will start requesting you to swap to blue adapter and later to gray.
After PROXI ALIGNMENT you have to make following calibrations. (before doing this move to level surface and adjust steering position to 0 deg.)
Calibrations in Continental ABS MK C1 module require gray adapter:
My video after successful installation:
Calibrations in Continental ABS MK C1 module require gray adapter:
- Run Lateral and longitudinal acceleration sensor calibration
- Reset steering angle
- Run Pressure sensor calibration
My video after successful installation: